Table of Contents
Advertisement
13/BRAKE SYSTEM
Checking the rear brake fluid level
16.13
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
Adding brake fluid to the rear brake circuit
16.14
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
–
Disconnect spring
–
Loosen nut
travel.
–
To adjust the basic position of the foot brake lever individually, loosen nut
turn screw
3
Info
The range of adjustment is limited.
–
Turn push rod
basic position of the foot brake lever.
Guideline
Free travel at foot brake lever
–
Hold screw
Guideline
Nut, foot brake lever stop
–
Hold push rod
Guideline
101378-10
Remaining nuts, chassis
–
Reconnect spring
–
Stand the vehicle upright.
–
Check the brake fluid level in the viewer
»
When in the viewer
–
Add brake fluid to the rear brake circuit. (
101379-10
.
1
and, with push rod
, turn it back until you have maximum free
4
5
accordingly.
accordingly until you have free travel
5
and tighten nut
.
3
2
and tighten nut
.
5
4
.
1
an air bubble is visible:
1
. If necessary, adjust the
A
3... 5 mm (0.12... 0.2 in)
M8
20 Nm
(14.8 lbf ft)
M6
10 Nm (7.4 lbf ft)
.
1
p. 102)
102
and
2
Advertisement
Table of Contents
