Table of Contents
Advertisement
04/SHOCK ABSORBER, SWINGARM
Checking the damper
8.17
Disassembling the rebound adjuster
8.18
Condition
The damper has been disassembled.
–
Measure the inside diameter on both ends and in the middle of the damper car-
tridge.
Damper tube
Diameter
»
If the measured value is greater than the specified value:
–
Replace the damper cartridge.
–
Check the damper cartridge for damage and wear.
»
If there is damage or wear:
200811-10
–
Replace the damper cartridge.
–
Check the heim joint for damage and wear.
»
If there is damage or wear:
–
Replace the heim joint.
–
Measure the diameter of the piston rod.
Piston rod
Diameter
»
If the measured value is smaller than the specified value:
–
Replace the piston rod.
–
Measure the run-out of the piston rod.
Piston rod
200812-10
Run-out
»
If the measured value is greater than the specified value:
–
Replace the piston rod.
–
Check the piston rod for damage and wear.
»
If there is damage or wear:
–
Replace the piston rod.
–
Check the piston rings for damage and wear.
»
If damage or a bronze-colored surface is visible:
–
Replace the piston rings.
200813-10
Preliminary work
–
Remove the spring. (
–
Disassemble the damper. (
–
Disassemble the piston rod. (
Main work
–
Warm up the piston rod in the area of the rebound damping valve seat.
Guideline
80 °C (176 °F)
–
Remove rebound damping valve seat
200805-10
50.08 mm (1.9716 in)
17.95 mm (0.7067 in)
0.02 mm (0.0008 in)
p. 45)
p. 46)
p. 47)
.
1
50
Advertisement
Table of Contents
