14/LIGHTING SYSTEM, INSTRUMENTS
Setting the clock
17.5
Checking the headlight setting
17.6
A
0 0 A
–
Press the button
The wheel circumference is displayed in millimeters.
Enlarging the wheel circumference
–
Press the button
Reducing the wheel circumference
–
Press the button
–
Press the button
–
Press the button
The settings are stored and the setup menu is closed.
400314-01
Info
If no button is pressed for 20 seconds, or if no impulse comes from the
wheel speed sensor, the settings are automatically saved and the Setup
menu is closed.
Condition
The motorcycle is stationary.
–
Press the button
the display.
–
Press the button
The hour display flashes.
–
Set the hour display with the button
–
Press the button
The next segment of the display flashes and can be set.
–
You can set the following segments in the same way as the hours by pressing the
button
and the button
400330-01
Info
The seconds can only be set to zero.
–
Press the button
The settings are stored and the Setup menu is closed.
Info
If no button is pressed for 20 seconds, or if no impulse comes from the
wheel speed sensor, the settings are automatically saved and the Setup
menu is closed.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
B
0 0 B
B
–
Position the vehicle vertically a distance
Guideline
Distance
A
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
.
.
.
briefly.
for 3 - 5 seconds.
briefly and repeatedly until CLK appears at the bottom right of
for 3 - 5 seconds.
and/or button
briefly.
.
for 3 - 5 seconds.
under the first mark.
B
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 108)
107
.