Rear Support Brackets Kit (Optional); Figure 3-3. Install The Optional Rear-Mounting Support Brackets Kit - Comtech EF Data LBC-4000 Installation And Operation Manual

3.2.1 Rear Support Brackets Kit (Optional)

Feature
1
2
Item
KT/6228-2
1 2
2 4
3 2
4 2
5 4
2
6
–

Figure 3-3. Install the Optional Rear-Mounting Support Brackets Kit

Tools needed to install the optional KT/6228-2 (4") or KT/6228-3 (10") Brackets Kit:
•
•
•
Do these steps to install the brackets kit (Figure 3-3):
1. Use the #10 flat washers, #10 split washers, and #10 hex nut to secure the #10 shoulder
screws to the unit chassis through the rear right and left side mounting slots as shown.
2. Mount the Rear Support Brackets to the rack enclosure threaded rear mounting rails
using the #10 Rear Support Bracket Bolts.
3. Slide the unit into the front of the rack enclosure. Make sure that the #10 Shoulder
Screws properly engage into the slots of the Rear Support Brackets.
Installation and Startup
Back of unit
Rack Enclosure Threaded Rear Mounting Rail (typical)
Kit / Quantity
KT/6228-3
2 HW/10-32SHLDR
4 HW/10-32FLT
2 HW/10-32SPLIT
2 HW/10-32HEXNUT
4 HW/10-32x1/2RK
– FP/6138-2
2 FP/6138-3
A medium Phillips screwdriver
A 5/32-inch SAE Allen Wrench
An adjustable Crescent wrench.
LBC-4000 L-Band Up/Down Converter System
Description
CEFD P/N
Shoulder Screw, #10
Flat Washer, #10
Lock Washer, #10
Hex Nut, #10
Bolt, #10, Rear Support Bracket
Bracket, Rear Support (4")
Bracket, Rear Support (10")
3–5
Revision 6
Description
MN-LBC-4000