Admin | Snmp; Figure 7-10. 'Admin | Snmp' Page - Comtech EF Data LBC-4000 Installation And Operation Manual

7.5.2.2

Admin | SNMP

Sect. 7.2 SNMP Interface
The Administrator must use this page to manage the SNMP settings.
SNMP
Click [Refresh] to update screen.
Name
Simple Network
Management
Read Community String
Write Community String
SNMP Contact
SNMP Name
SNMP Location
Enable Authentication Trap
Trap IP 1
Trap IP 2
Trap Version
Trap Community String
Click [Submit SNMP] to accept the changes.
Click [Reset] to revert to the previously assigned settings.
Ethernet Interface Operation

Figure 7-10. 'Admin | SNMP' Page

Use the drop-down list to select Enabled or Disabled.
Automatically populates as public.
Automatically populates as private.
Enter this identity information in any alphanumeric combination with a length of
0 to 20 characters.
Enter this identity information in any alphanumeric combination with a length of
0 to 20 characters.
Enter this identity information in any alphanumeric combination with a length of
0 to 20 characters.
Use the drop-down list to select Enabled or Disabled.
The Administrator can assign up to two SNMP Trap IP Addresses.
The Administrator can assign up to two SNMP Trap IP Addresses.
Use the drop-down list to select the version as SNMPv1 or SNMPv2.
This can be any combination of characters and a length of 0 to 20 characters.
The factory default for the SNMP Trap Community String is "comtech".
7–15
LBC-4000 L-Band Up/Down Converter System
Description
Revision 6
MN-LBC-4000