Http Interface Used For Firmware Information; Serial Interface Used For Firmware Information - Comtech EF Data LBC-4000 Installation And Operation Manual

5.2.3.2

HTTP Interface Used for Firmware Information

Chapter 7. ETHERNET INTERFACE OPERATION
Do these steps:
1. Go to either of these pages to review the firmware information:
•
•
2. Write down your firmware information for further reference or to provide to Comtech EF
Data Product support.
5.2.3.3

Serial Interface Used for Firmware Information

Chapter 8. SERIAL INTERFACE OPERATION
Use your terminal emulator program to execute remote queries with the LBC-4000/-ST. Use the
"FRM" or "FRW" remote query to find the pertinent firmware information:
•
<DEV/FRM_{cr}
(returns the current (Ethernet-ready) firmwares running under Boot, Bulk1, and Bulk2 in
the form FW-AAAAAAA; B.B.B; DD/MM/YY, where:
o
o
o
•
<DEV/FRW_{cr}
(returns the legacy (Serial operation only) firmwares in the form:
o
o
o
Firmware Update
The 'Firmware Information' section of the 'Config | Utility' page provides the
firmware details as Boot, Bulk1, and Bulk2, as shown in this example:
The 'Summary' section of the 'Status | Summary' page provides the firmware
details – "FW Revision", "Active Software Image", and "Next Reboot Image" – as
shown in this example:
FW-AAAAAAA = the firmware part number
B.B.B = the firmware version number
MM/DD/YY = the firmware release date (Month/Day/Year)
BULK=FW/9965X (where X is the Revision Letter)
M&C=FW/9966X (where X is the Revision Letter)
FPGA=FW/9967X (where X is the Revision Letter)
LBC-4000 L-Band Up/Down Converter System
5–5
Revision 6
MN-LBC-4000