Firmware:) Select - Comtech EF Data LBC-4000 Installation And Operation Manual

6.3.6.3.1.2 (FIRMWARE:) INFOIMAGE#1/#2
Where '#X' denotes the IMAGE#1 or IMAGE#2 firmware load, the IMAGE#1 and IMAGE#2
firmware load info screens are nested as follows:
Use the [][] arrow keys to select Bulk, App, or FPGA. Press [ENT].
(FIRMWARE:) INFOIMAGE#1/#2BULK
(FIRMWARE:) INFOIMAGE#1/#2APP
(FIRMWARE:) INFOIMAGE#1/#2FPGA
6.3.6.3.2

(FIRMWARE:) SELECT

Use this submenu to select the Current Active Firmware Image. The read-only top line shows the
Current Active Image.
On the bottom line: Use the [][] arrow keys to select #1 or #2 as the Next Reboot Image (i.e.,
the image that will be active the next time the unit is rebooted). Press [ENT].
If the image that you select is already set as the designated Next Reboot Image, this message
displays:
You may repeat the task by instead selecting the alternate image.
Front Panel Operation
IMAGE#X: Bulk APP FPGA
Bulk#X: FW-0020503
X.X.X MM/DD/YY
App#X: FW-0020504
X.X.X MM/DD/YY
FPGA#X: FW-0020505
X.X.X MM/DD/YY
Current Active Image: #1
Next Reboot Image: #1 #2
THAT IMAGE IS ALREADY
CURRENT. NO CHANGE MADE.
LBC-4000 L-Band Up/Down Converter System
6–19
Revision 6
MN-LBC-4000