Configure Hyperterminal For Telnet Remote Control Operation; Figure 7-3. Configure Hyperterminal - Comtech EF Data LBC-4000 Installation And Operation Manual

7.3.1.1

Configure HyperTerminal for Telnet Remote Control Operation

See Figure 7-3. Do these steps:
1. Make sure to define the Connect To Telnet connection properties correctly (File 
Properties) (Figure 7-3, left):
a. Enter the unit's Traffic/Management IP Address as the "Host address" (e.g.,
b. Enter TCP Port 23 as the "Port number".
c. Set "Connect using" to TCP/IP (Winsock) instead of COM1 or COM2.
d. Click [OK] to save your settings.
2. For ASCII Setup (File  Properties  Settings  ASCII Setup) (Figure 7-3, right side):
a. Check the "Send line ends with line feeds" option in the 'ASCII Sending' section.
b. Check the "Append line feeds to incoming line ends" option in the 'ASCII
c. Click [OK] to save your settings.
Ethernet Interface Operation
192.168.1.1).
Receiving' section.

Figure 7-3. Configure HyperTerminal

LBC-4000 L-Band Up/Down Converter System
7–5
Revision 6
MN-LBC-4000