7.5.3.5
Config | Serial
Use this page to configure the operating parameters over the EIA-485/232 serial interface.
Serial
Click [Refresh] to update screen.
Serial
Name
Interface Type
Remote Address
Baud Rate
Data bits – Prity – Stop bits
Click [Change Serial Configuration] to update the changes.
Ethernet Interface Operation
Figure 7-15. Config | Serial page
Use the drop-down menu to select the operating serial mode as RS-485 or RS-232.
Enter a valid remote control address from 0001 to 9999.
Use the drop-down menu to select the operating baud rate as 1200, 2400, 4800,
9600, 19200, or 38400 baud.
Use the drop-down menu to select the asynchronous character format as 8-N-1 (8
data bits, no parity, 1 stop bit); 7-O-2 (7 data bits, odd parity, 2 stop bits); or 7-E-2 (7
data bits, even parity, 2 stop bits).
7–21
LBC-4000 L-Band Up/Down Converter System
Description
Revision 6
MN-LBC-4000