Comtech EF Data LBC-4000 Installation And Operation Manual page 109

Typical for all STATUS columns, when any operating parameter is within acceptable limits, the
STATUS indicates OK within a green box. If a fault condition exists, the message changes to
FAULT within a red box.
Summary
Click [Refresh] to update screen.
Name
Parameter STatus
Converter A / B Status
Converter A / B, PS (Power
Supply) A / B, Monitor and
Status
Notes:
1. Valid Converter A/Converter B LNA Current readings are provided only if the pertinent
LBC-4000/-ST Block Down Converter (BDC) is optionally configured with an LNA. These
parameters otherwise display as N/A if the pertinent converter is a BUC.
2. Valid Converter A/Converter B Forward RF Power readings are provided only if the
pertinent LBC-4000/-ST Block Up Converter (BUC) is optionally configured with the
Power Monitor feature. These parameters otherwise display as N/A if the pertinent
converter is a BDC.
3. Valid Power Supply 2 and Local Switch Position information is provided with redundant
configurations only.
Ethernet Interface Operation
Product identification (i.e., CID/AID, serial and model numbers), active firmware,
software image information, and other operational configuration information is
provided here.
This section identifies the converter installed in each module slot (BUC or BDC) and
each module's associated RF conversion band and frequency, attenuation value,
mute status, and online/offline status.
This section provides the current monitored value for each module (BUC or BDC),
including the RF/IF lockout status, operating voltages and temperatures. The
operating voltages for each power supply are also provided.
7–23
LBC-4000 L-Band Up/Down Converter System
Description
Revision 6
MN-LBC-4000