Comtech EF Data LBC-4000 Installation And Operation Manual page 76

View or edit the SNMP Write Community string. Use the [][] arrow keys to select a character,
and then the [][] arrow keys to edit that character. Press [ENT].
(REMOTE:) ETHERNETSNMPCOMMUNITIESTRAP
View or edit the SNMP Trap Community string. Use the [][] arrow keys to select a character,
and then the [][] arrow keys to edit that character. Press [ENT].
(REMOTE:) ETHERNETSNMPTRAPS
Use the [][] arrow to select TRAPIP1, TRAPIP2, or VERSION. Press [ENT].
(REMOTE:) ETHERNETSNMPTRAPSTRAPIP1/TRAPIP2
If both Trap IP Addresses are set to 000.000.000.000, it means that Traps are
disabled.
Typical for both submenus: View or edit the Trap Destination IP Address. Use the [][] arrow
keys to select a digit, and then the [][] arrow keys to change its value. Press [ENT].
(REMOTE:) ETHERNETSNMPTRAPSVERSION
Use the [][] arrow keys to set the trap version as SNMPv1 or SNMPv2. Press [ENT].
Front Panel Operation
Trap Community:
comtech
TRAPIP1 TRAPIP2 VERSION
TRAP IP ADDRESS #1:
000.000.000.000
TRAP IP ADDRESS #2:
000.000.000.000
Trap Version:
SNMPv1 SNMPv2
LBC-4000 L-Band Up/Down Converter System
6–12
Revision 6
MN-LBC-4000