Creflash" Used To Upload The Firmware Files - Comtech EF Data LBC-4000 Installation And Operation Manual

5.4.2 "CReflash" Used to Upload the Firmware Files

1. The "CReflash" utility is provided with the firmware download.
2. Serial-only (i.e., non-Ethernet) units must use this procedure.
Do these steps:
1. From the temporary folder – Locate, and then double-click, the "CReflash" filename or
icon. The CReflash utility opens:
2. Enter your upload parameters information into CReflash:
a. Left-click in the "IP Address:" text box, and enter the default Management IP
b. Left-click in the "Local Filename:" text box. Then, click [Browse] and navigate to
c. Make sure the drop-down list remains set to "bulk:".
d. Click [Start] to begin the upload process. If the information was correctly entered
3. When done, click [Cancel] to exit CReflash.
Firmware Update
Address.
the temporary folder created earlier. Click on the firmware "bin" filename, and
then click [Open]. The filename will appear in the "Local Filename:" text box.
into CReflash, the utility displays an animated progress bar at the bottom of the
window, along with a series of messages:
•
"Opening FTP"
•
"Sending data file to modem:"
•
"Writing FLASH: # of #"
•
"Success!"
LBC-4000 L-Band Up/Down Converter System
5–12
Revision 6
MN-LBC-4000