Select: Config (Configuration) Menus - Comtech EF Data LBC-4000 Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System
Front Panel Operation
Each menu branch available from the SELECT: menu, its content section in this chapter, and the
functional description of each branch is identified as follows:
Menu Branch
Config
Monitor
Faults
Util
Use the [←][→] arrow keys to select from the choices shown, and then press [ENT].
5.2.1

SELECT: Config (Configuration) Menus

CONFIGURE: Conv-A Conv-B
Remote Redund RefAdj
Use the [←][→] arrow keys to select from the submenu choices shown, and then press [ENT].
Each submenu available from the Configuration menu branch – typical for Converter A or
Converter B – its content section in this chapter, and the functional description of each submenu
is identified as follows:
Submenu
Conv-A
Conv-B
Remote
Redund
RefAdj
Sect Description
5.2.1
(Configuration) Use to fully configure the LBC-4000A.
Use to monitor the alarm status of the unit, view the log of stored events, and
5.2.2
display the Receive Parameters screen.
Use to view information on the unit, without having to access configuration
5.2.3
screens.
(Utility) Use to perform miscellaneous functions, such as setting the Real-time
5.2.4
clock, adjusting the display brightness, etc.
Sect Description
(Converter Unit A or B) Displays the current configuration of the selected
5.2.1.1
converter, including the frequency, attenuation, and slope.
(Remote Control) Defines whether the unit is being controlled locally or
5.2.1.2 remotely, and identifies the unit address, interface type, and rate and format of
the baud parameters.
(Redundancy – overview only) Identifies the redundancy state and mode
5.2.1.3 (refer to Appendix B. LBC-4000 REDUNDANCY OPERATION for detailed
information).
5.2.1.4 (Reference Oscillator Adjustment) Adjusts the reference oscillator.
5–6
Revision 4
MN/LBC4000.IOM