Disabling The Power Switch Cover Security Feature - Compaq ProLiant 800 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-30 Installing Hardware Options
Disabling the Power Switch Cover Security
Feature
The entire switch cover assembly can be made to depress with your finger, not
requiring the eraser end of a pencil.
!
1. Remove the Side Access Panel.
2. Remove the front bezel.
3. Locate the two clips securing the switch cover in the front bezel on the
rear side of the bezel assembly.
4. Use a narrow instrument to release each clip from the bezel
by pushing inward slightly.
5. Once each clip is disengaged, remove the switch cover parts from the
bezel
disengage from the bezel. Tension in the spring may cause it to come
loose, so be careful not to lose the spring.
Figure 3-24. Removing the power switch from the front bezel
WARNING:
Before removing the front bezel, ensure that the
computer is turned off and that the power cord is disconnected from
the electrical outlet.
, collecting the two plastic parts and the spring as they
Writer: Project: Installing Hardware Options Comments:
File Name: E-ch3.doc Last Saved On: 4/23/97 11:22 AM
and