Compaq ProLiant 800 Manual page 54

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Pager Data
Network
frame type
Network IP
address
Network IP
net mask
Network IP
router
address
If you configure the server to boot into Compaq Utilities, the server prepares
for remote communications, so you can remotely run Diagnostics software,
Inspect Utility, or System Configuration Utility using a workstation running
terminal emulation software, such as Compaq Insight Manager or PC
Anywhere.
continued
Setting
ETHERNET_I Select the frame type for your network. Selections
I include both Ethernet and Token Ring topologies.
Enter the IP address for this server in standard dot
notation.
NOTE: This is not used if you select Custom for
Network controller. You must enter your IP address in
the NET.CFG file that you load into the system partition.
Enter the net mask for this server in standard dot
notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the
NET.CFG file that you load into the system partition.
Enter the router to be used for this server in standard
dot notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the
NET.CFG file that you load into the system partition.
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Description
Compaq ProLiant 800 Server Reference Guide
2-25