Compaq ProLiant 800 Manual page 51

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-22 Server Management
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Pager Data
Pager test
Serial
interface
Dial-in
status
continued
Setting
Select to Use this to test the current pager settings. Press Enter
test to dial the pager number, and the pager message (if
pager setup present) displays. You must configure the server before
testing the pager and the Pager Status must be set to
Enabled. Do not test the pager if you are running
remotely and are using only one modem.
COM1 Select the communications port for the modem used by
the pager and the remote ASR-2 functions. The options
are COM1 and COM2.
Enabled Set Dial-In Status to Enabled. Be sure the Reset Boot
option is set to Boot Compaq Utilities. When the system
starts because of an ASR reset, it starts the Compaq
Utilities, sets the Management Modem to auto-answer,
and waits for the administrator to dial in and run the
Compaq Utilities.
You automatically disable this option when you
configure the software error recovery start option to
Boot Operating System. When ASR pages you, you
cannot dial in unless ASR-2 exceeds 10, the threshold
number of server restart retries. When this happens,
ASR-2 restarts the server into the Compaq Utilities and
places the modem in auto-answer mode.
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Description
continued