Compaq ProLiant 800 Manual page 44

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If you have configured for dial-in access and have a modem with an auto-
answer feature installed, you can dial in and remotely diagnose or reconfigure
the server.
If you have configured the Compaq Utilities for network access, you can
access the utilities over the network. You can use Compaq Insight Manager
for dial-in or network access.
Hardware Requirements
To use this level of ASR-2 over a modem, you need the following:
Compaq modem or optional Hayes modem
System Configuration Utility and Diagnostics Utility installed on the
system partition of the hard drive
ASR-2 configured to load Compaq Utilities after restart
You may also run Compaq Utilities remotely over an IPX or IP network using
the Network feature:
To use Compaq Utilities on an IPX network, you must have Compaq
Insight Manager 2.0 or later or an NVT (Novell Virtual Terminal)
Terminal Emulator with VT100 or ANSI terminal capabilities.
To use Compaq Utilities on an IP network, you must have Compaq
Insight Manager 2.10 or above or a Telnet Terminal Emulator with
VT100 or ANSI capabilities.
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Compaq ProLiant 800 Server Reference Guide
2-15