Compaq ProLiant 800 Manual page 166

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8-36 Diagnostics Tools
Message
Accelerator board not
detected
Accelerator error log
Accelerator parity read
errors: n
Table 8-2
DAAD Diagnostic Messages
Description
Array controller did not
detect a configured array
accelerator board.
List of the last 32 parity
errors on transfers to or
from memory on the array
accelerator board. Displays
starting memory address,
transfer count, and
operation (read and write).
Number of times that read
memory parity errors were
detected during transfers
from memory on array
accelerator board.
Writer: Project: Diagnostics Tools Comments:
File Name: J-ch8.doc Last Saved On: 4/24/97 10:38 AM
Recommended Action
Install array accelerator board on array
controller. If an array accelerator board is
installed, check for proper seating on the array
controller board. You may need to run the
System Configuration Utility and disable the
array accelerator board to get this message off
the screen.
If there are many parity errors, you may need
to replace the array accelerator board.
If there are many parity errors, you may need
to replace the array accelerator board.
continued