Compaq ProLiant 800 Manual page 50

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
You can also enable ASR-2 to allow network access using the Network Status
feature in the System Configuration Utility. You must have either Compaq
Insight Manager 2.0 or greater or a Novell Virtual Terminal (NVT) emulator
on an IPX network to use this feature. You must also have version 2.24 or
later of the System Configuration Utility. For IP access, you must have either
Compaq Insight Manager 2.10 or above or a Telnet Terminal emulator to use
this feature. You also must have version 2.24 or later of the System
Configuration Utility.
The System Configuration Utility settings should resemble the following when
you enable ASR-2 to start into Compaq Utilities:
Pager Data
Pager status
Pager dial
string
Pager
message
Table 2-3
Compaq System Configuration Utility
Pager Settings for Booting into Compaq Utilities
Setting
Enabled Indicates if the pager feature is enabled or disabled.
ATDT 555- Indicates the pager dial string and delay before the
5555 pager message. Pagers typically use one of the following
formats:
Local pagers: ATDT 555-5555,,
Wide area pagers: ATDT 1-800-555-5555,,,,,1234567#
1234567# Represents a unique number (maximum seven digits,
numeric only) that you must designate to identify the
server on your pager display. The ROM adds a three-
digit code to the front of this number. The first two
indicate the subsystem and the third indicates the
severity of the error that caused the alert. The # symbol
usually terminates the message. If no message is
required, delete the # symbol.
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Description
continued
Compaq ProLiant 800 Server Reference Guide
2-21