Installing Hardware Options; Removing The Expansion Backplane Brace - Compaq ProLiant 800 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-4

Installing Hardware Options

Removing the Expansion Backplane Brace

1. Turn off the server and disconnect the power cord.
2. Disconnect any other external equipment connected to the server.
3. Remove the side access panel.
4. Grasp the expansion backplane brace at both ends and pull it out of the
server chassis. Use care when guiding the assembly out of the unit to
prevent damaging the boards.
Figure 3-2.
CAUTION:
Before an expansion board can be installed or replaced, you
must remove the expansion backplane brace that holds the expansion
cards. Follow these steps to safely remove the expansion backplane brace.
Removing the expansion backplane brace
Writer: Project: Installing Hardware Options Comments:
File Name: E-ch3.doc Last Saved On: 4/23/97 11:22 AM