Table of Contents
Advertisement
Electrical
Connect Color Change Module
To install the color change module(s), see manual
312787.
Connect a 5-pin electrical cable from the labeled con-
nection port
(J11) on the fluid station control
board to the color change board. See F
If you are using two color change modules to add colors,
connect a 5-pin electrical cable from the first color
change board to the second color change board.
Color Change Board 1
S3
S6
Termination
Resistor
Board ID
OFF
ON
ON
ON
24
. 12.
IG
Table 2: Color Change Board Switch Settings
Two Color Change Boards
S5
S4
Catalyst
Color
Termination
On/Off
On/Off
Resistor
OFF
ON
One Color Change Board
OFF
ON
Set switches S3-S6 on the color change board(s) as
shown in Table 2 and F
of color change boards and color change modules being
used in your system.
For wiring between the color change board and the sole-
noids, see the color change module electrical sche-
matic, F
. 13.
IG
Color Change Board 2
S3
S6
S5
Catalyst
Board ID
On/Off
ON
OFF
NOT USED
. 12, depending on the number
IG
S4
Color
Effect on System
On/Off
NOT USED
0 catalyst valves, 30 color
valves
0 catalyst valves, 12 color
valves
3A1163A
Advertisement
Table of Contents
