11. 11Scale Command Messages - Xerox DocuPrint 96 Message Manual

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE

11. 11SCALE command messages

The SCALE command enables scanned graphic images (fonts,
forms, and logos) to print at an enlarged or reduced size under
certain conditions. Refer to your DocuPrint 96/DocuPrint 96MX LPS
Operations Reference chapters on HIP-accessed communicating
modes and using graphics for detailed information about the SCALE
command.
**Cannot open input file: xxxx
The requested input file is not found.
Action Verify the input file name and reenter the command. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference chapter
on managing LPS resources for additional information.)
**Cannot open output file: xxxx
The requested output file cannot be created or the required space is
not available on the disk.
Action 1. Verify the output file name and reenter the command. (Refer to
your DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on managing LPS resources for additional information.)
2. Compress the disk(s) to free more contiguous (adjoining)
sectors on the disk(s).
**Cannot scale files of requested type: xxxx
The requested file cannot be scaled.
Action Verify the file type and reenter the command. The file type must be
FRM, FNT, FN6, LG0, or LG6. (Refer to your DocuPrint 96/DocuPrint
96MX LPS Operations Reference chapter on managing LPS
resources for additional information.)
**Dashing not supported**
Scaling of the requested form has produced a pattern of lines and
spaces that SCALE cannot equate to 600 spi.
Action None.
**DIAG - CHAR x in yyyy exceeds byte escape; set to 0. 425in**
The character named in the message has a width that has been set
to .425 by SCALE. Widths that have been overridden in this way no
longer represent the actual size of the characters and may yield
output which appears compressed
Action None.
11-1