Xerox DocuPrint 96 Message Manual page 228

SCALE COMMAND MESSAGES
11-2
**EDIM META-Code not supported**
The extended dimension (EDIM) function cannot be scaled to 600
spi.
Action None.
Enter Input file name or <RETURN> to exit.
An input file name must be included in the command to invoke
SCALE.
Action Enter the input file name
or
Press the <RETURN> key to exit this activity.
**Error (n.n) generating Output File**
The system is unable to generate the output file.
Action 1. Check the SCALE command and reenter.
2. If the message reappears, contact your systems specialist or
Xerox Customer Support.
**Error (n.n) reading Input File**
There is a problem reading the input file. This is a disk error, e.g., a
bad block.
Action 1. RNAME input file to a well-known name (e.g., BADnnn.TMP).
2. Restore the file from a backup source (e.g., tape, floppy, or
host).
3. Recreate the file using FDL if an FRM file.
4. Contact your systems specialist or Xerox Customer Service to
log the bad sector and delete the well-known name.
File already exists, overwrite xxxx (Yes or No)?
The requested file already exists.
Action If you want to overwrite the existing file, enter YES.
or
Enter NO if you do not.
**File type for output name must be xxxx or yyyy**
The file type for the output name must be as listed in the message.
Action Reenter the SCALE command using the correct file type in the output
name. (Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations
Reference chapter on managing LPS resources for additional
information.)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE