Xerox DocuPrint 96 Message Manual page 220

PR (HARDCOPY GRAPHICS PRINTING COMMAND) MESSAGES
9-2
PR2600 Not enough space on disk to hardcopy.
The selected file cannot be hardcopied because the print file is not
large enough to hold it
Action 1. Use the REALLOCATE command to enlarge the print file.
(Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations
Reference chapter on setting LPS parameters for additional
information.)
2. Reenter the HARDCOPY command.
PR2710 Scale factor invalid, check and retry.
The "n/d" scale parameter of the HARDCOPY command was entered
incorrectly.
Reenter the command correctly. (Refer to your DocuPrint 96/
Action
DocuPrint 96MX LPS Operations Reference chapter on running print
jobs.)
PR2720 HPOS value out of range, check and retry.
The number entered for horizontal position (hpos) parameter of
HARDCOPY command was beyond the permitted range.
Reenter the command correctly. (Refer to your DocuPrint 96/
Action
DocuPrint 96MX LPS Operations Reference chapter on running print
jobs for additional information.)
PR2730 VPOS value out of range, check and retry.
The number entered for the vertical position (vpos) parameter of
HARDCOPY command was beyond the permitted range.
Action Reenter the command correctly. (Refer to your DocuPrint 96/
DocuPrint 96MX LPS Operations Reference chapter on running print
jobs for additional information.)
PR2760 File not found, check and retry.
The file specified in the "file name" parameter of HARDCOPY
command does not exist on system disk.
Action 1. Verify the desired file name and reenter the command.
2. If the message reappears, load the desired .IMG file to disk.
(Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations
Reference chapter on setting LPS parameters for additional
information.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE