Xerox DocuPrint 96 Message Manual page 203

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS9210 Parity error on input medium.
A parity error has been discovered in the magnetic tape input buffer
in CPU memory. (The error was not reported by the magnetic tape
drive itself.)
or
The message also appears if attempting to read a 6250 bpi tape on
a 1600 bpi magnetic tape drive.
Action 1. Clean the magnetic tape drive. (Refer to the maintenance
chapter in your DocuPrint 96/DocuPrint 96MX LPS Operator
Guide .)
2. Check the tape density.
3. Restart the job and/or mount a tape of correct density for the
tape drive.
4. If the problem continues, contact your systems specialist or
Xerox Customer Service.
OS9300 Page set-up error. Page won't be printed. ABORT O or
The page cannot be printed because a dispatching error has
occurred three consecutive times. This may be due to data
exceeding the capability of the character dispatcher. (Message is
followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command. The job will print with one
page missing.
or
Enter the ABORT O command to cancel the report.
2. Recreate the job, reducing the amount of data per page.
Note: CRT refers to the DocuPrint 96/DocuPrint 96MX LPS
System controller display.
OS9305 Duplex set-up error. Page won't be printed. ABORT O or
The page cannot be printed because the front side of a page printed
on both sides (duplex) contains more data than can be retrieved and
set up by the system. (This message is followed by message
OS2000.)
Action 1. Enter the CONTINUE O command for the job to print with one
page missing.
or
Enter the ABORT O command to cancel the report.
2. Recreate the job, reducing the amount of data per page.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-125