Xerox DocuPrint 96 Message Manual page 142

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-64
OS2710 Invalid command reenter.
A command was entered that the system does not recognize, or a
command was improperly keyed in.
Action 1. Reenter the command correctly.
2. If the message reappears, the command cannot be used with
your system.
OS2711 CMD not allowed while diagnostic print job is in progress.
You have entered a command that cannot be processed because a
diagnostic print job is being run.
Action None.
OS2712 Command not allowed while task is running.
The command entered cannot be processed while the current task is
ongoing.
Action 1. Abort the current task or wait until it is completed.
2. Reenter the desired command.
OS2713 This command is no longer supported. See -11
The command entered is obsolete; your system cannot respond.
Action 1. Refer to your DocuPrint 96/DocuPrint 96MX LPS OSS Program
Description ("-11") for the correct command for the desired
process.
2. If information cannot be located, contact your systems
specialist or Xerox Customer Support.
OS2714 Unable to obtain status at this time. Retry
The PRNTRSTATUS or JOBS command cannot be honored at this
time. The PRNTRSTATUS command will not be honored while
output is establishing communications. The JOBS command may not
be honored if either input or output is performing a report transition or
is near the end of the job.
Action Retry.
OS2715 Command ignored, retry later.
The command entered cannot be processed because it conflicts with
an ongoing process.
Action Reenter the command after the process is completed.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE