Xerox DocuPrint 96 Message Manual page 89

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1006 Printer is not available; Printer is being serviced
The printer is unable to respond to the entered command because
the Xerox service representative is performing diagnostic tests.
The printer control console displays one of the following messages
for use of the service representative only:
BILLING METER A = xxxxxxxx
BILLING METER C = xxxxxxxx
BILLING METER E = xxxxxxxx
BILLING METER F = xxxxxxxx
BILLING METER H = xxxxxxxx
BILLING METER J = xxxxxxxx
CUSTOMIZED PROGRAMS--ENTER NUMBER: 00 OR PRESS P
AGAIN TO VIEW PROGRAM LIST
KEY OPERATOR PROGRAM--PRESS START TO RESET OR C
TO EXIT
PRESS P TO REPEAT LIST
PRESS C TO EXIT
PRESS START TO DISPLAY BILLING METER(S) OR PRESS C TO
EXIT
PRESS START TO INITIATE SERVICE TEST SEQUENCE
P10 DISPLAY BILLING METERS. PRESS START TO SELECT OR
P TO VIEW MORE
P72 SERVICE TEST SEQUENCE. PRESS START TO SELECT OR
P TO VIEW MORE
P73 SYSTEM RESET. PRESS START TO SELECT OR P TO VIEW
MORE
xx IS AN INVALID CUSTOMIZED PROGRAM NUMBER. PRESS P
TO TRY AGAIN
Action None.
OS1007 Printer is busy
A command was entered while the printer was warming up or
adjusting print quality. The command will be ignored until the printer
completes activity.
Action 1. Check the printer control console for explanatory messages.
2. Wait until READY TO PRINT appears on the printer control
console and reenter the command.
OS1008 Printer is busy, command ignored
The PQA or SUBSTITUTE INK command you have entered is
rejected because the printer is busy processing a job.
Action Retry the PQA or SUBSTITUTE INK command after the printer has
cycled down.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-11