Xerox DocuPrint 96 Message Manual page 84

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-6
OS0801 NVM update complete
The periodic acquisition of information from the printer control
console has been completed.
Action None.
OS0830 Attention Light enabled.
The LIGHT ENABLE command is entered and accepted.
Action None.
OS0831 Attention Light disabled.
The LIGHT DISABLE command is entered and accepted.
Action None.
OS0840 Entering Lockout Mode
The lockout diagnostic mode is active.
Action None.
OS0845 Exiting Lockout mode
The lockout diagnostic mode has been terminated.
Action None.
OS0850 Print Quality Adjustment pending
This message is displayed after you have entered a valid PQA
command and usually accompanies other related messages.
Action Enter the CONTINUE command, or press the <CON> key to initiate
PQA.
OS0851 Paper tray: x Output tray: n
This message identifies the paper and output tray numbers involved
in the current PQA operation and may accompany other related
messages.
Action None.
OS0852 Cluster: xxxxx Output tray: n
This message identifies the cluster name and output tray number
involved in the current PQA operation and may accompany other
related messages.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE