Xerox DocuPrint 96 Message Manual page 34

HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-12
HP2300 Command error at: part of command in error
The command part indicated was entered incorrectly.
Action Reenter the command correctly. (Refer to the HIP chapter in your
DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
HP2310 Reenter command
An incorrect command was entered.
Action Reenter the correct command. (Refer to the HIP chapter in your
DocuPrint 96/DocuPrint 96MX LPS Operator Guide .)
HP2320 Invalid command with current host type
The command entered is not correct for the current host.
Action Enter the command appropriate for your current host. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference chapter
on HIP-accessed communicating modes for additional information.)
HP2330 Invalid command with no host specified
A host must be selected before the command can be carried out.
Action 1. Select a host. (Refer to your DocuPrint 96/DocuPrint 96MX LPS
Operations Reference chapter on HIP-accessed
communicating modes for additional information.)
2. Reenter the command.
HP2340 Cannot change: HIP must be in 'STOP' state.
To invoke the CHANGE command, HIP must be in the STOP state
and the file must be completely received and in the PENDING state.
Action None.
HP2341 Cannot change: job must be in 'PENDING' state.
To invoke the CHANGE command, HIP must be in the STOP state
and the file must be completely received and in the PENDING state.
Action None.
HP2342 Cannot change: change process already active.
Only one CHANGE command can be invoked at one time.
Action Allow the current change process to complete before invoking
another.
HP2343 Cannot change: invalid file specification.
The output file-type is either invalid or not a type specified in the
ACCEPT list.
Action None.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE