Xerox DocuPrint 96 Message Manual page 119

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1962 The 'PQA CONTINUE' parameter is not allowed with the current
selections.
For the DocuPrint 96/DocuPrint 96MX LPS, you have entered the
PQA command with the CONTINUE option, but have not met the
requirements that allow the CONTINUE keyword with PQA.
Action 1. Make sure you define the feeder trays containing the required
stock for PQA as current trays in a valid cluster.
2. With the dual stacker you must specify different output trays for
PQA and the print job. (Refer to your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide, chapter 6, "Running print
jobs," for more information.)
OS1963 Print quality adjustment is already pending.
This message is displayed if a PQA command is entered while
another one is pending. The second PQA command is ignored.
Action Use PQA CANCEL to cancel the first (pending) PQA.
OS1964 No print quality adjustment is pending.
This message is displayed if you enter the PQA CANCEL command
when there is no print quality adjustment pending.
Action None.
OS1965 Print quality adjustment was unsuccessful.
For any of a number of reasons, print quality adjustment fails to
complete.
Action 1. Retry running PQA.
2. Contact your supervisor or Xerox Support if the message
continues to appear.
OS1967 CAUTION: 'CONTINUE' may cause job sheets to be stacked on
top of adjustment sheets.
You have entered the CONTINUE option with the PQA command on
a system with only one output tray (finisher). Note that the sheets of
paper for your job may be stacked on top of the sheets used for print
quality adjustment (PQA).
Action None.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-41