Xerox DocuPrint 96 Message Manual page 111

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1560 Tape rewind complete
The system has finished rewinding the tape.
Action None.
OS1561 Font mapping does not exist for file-name.FNT.
There is no font mapping to run the job. Job processing will continue
using the font specified in the PDE.
Action If you wish to override the PDE font, reenter the command using valid
font mapping.
OS1562 Font file not found for file-name.FNT.
You have specified a font file that does not exist in the system. Job
processing will continue using the font specified in the PDE
statement.
Action If you wish to override the PDE font, verify the font file and reenter the
command.
OS1563 SEF file not found
You have specified that the font mappings you wish to use in the job
are contained in a file that does not exist in the system. Job
processing will continue using the font specified in the PDE
statement.
Action If you wish to override the PDE font, verify the mapping file and
reenter the command.
OS1570 File protected--unable to dump
The system cannot print dump because the file is protected by the
SECURE filename.filetype command.
Action 1. Obtain the correct password and log on at Level 5. (Refer to
your DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on setting LPS parameters for additional information.)
2. Retry printout.
OS1580 Can't print Ethernet error page - missing font
An Ethernet-transmitted job contains errors. The error page will not
print because the required font was not found on the system disk.
Action 1. Load the necessary font file to disk. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on HIP-accessed communicating modes for additional
information.) Contact your systems specialist or Xerox
Customer Support for information on the correct font to load.
2. Restart the job.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-33