Xerox DocuPrint 96 Message Manual page 101

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1291 Cluster name not defined.
or
Cluster <cluster-name> ***
Cluster has no current trays ***
You have entered a PQA command or a job start command
containing an undefined cluster or one with no current trays.
Action 1. Verify the clusters to be used for your job.
2. Reenter the PQA command.
OS1292 Command ignored.
Main or Aux Cluster not selected
The FEED command can only cause the system to toggle between
the MAIN and AUX clusters. Since neither MAIN nor AUX had been
selected, this command has been ignored.
Action Enter the name of the specific cluster you wish to select. (Refer to
your DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on setting up print jobs for additional information.)
OS1293 Feed Main/Aux not in effect, unable to toggle
The system is unable to switch (toggle) between the main and
auxiliary feeder trays.
Action Check your cluster configuration and enter a new command that will
allow toggling. (Refer to the chapter on feeder trays in your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference .)
OS1294 Invalid paper tray selected. Command ignored
A command was entered that refers to a (feeder) tray not in the
printer configuration, e.g., (feeder) trays 3 and 4 can only be selected
when your printer has a high-capacity feeder.
Action Select a (feeder) tray that is part of your printer's configuration.
(Refer to the chapter on feeder trays in your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide .)
OS1295 Destination trays not configured for this command
A command was entered that is invalid for the printer's stacker tray
configuration.
Action Reenter the command, using a stacker bin that your system has.
(Refer to the output tray or bin chapter in your DocuPrint 96/
DocuPrint 96MX LPS Operator Guide .)
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-23