Add Circuit Packs; Connect Cables; Administer The Circuit Pack; Resolve Alarms - Avaya S8700 Manual

Install and Administer Trunks and Lines

Add Circuit Packs

Before physically installing the circuit pack, you need the assigned slot location (UUCSS), where UU is
the media gateway (MCC1, SCC1) or port network number, C is the media gateway or carrier (MCC1),
and SS is the slot location. The information is available from the person who adminstered the translations
(most likely the software specialist). If not, you can find the information on the Trunk Group Status
screen.
1
Get the trunk group number from the administrator.
2
Type status trunk-group number and press
status trunk 1
Member Port
0001/001 13A0701
0001/002 13A0702
0001/003 13A0703
0001/004 13A0704
0001/005 13A0705
0001/006 13A0706
0001/007 13A0707
0001/008 13A0708
0001/009 13A0801
0001/010 13A0802
0001/011 13A0803
0001/012 13A0804
0001/013 13A0805
0001/014 13A0806
3
Install the DS1 Interface circuit pack in the assigned slot.
4
Install a Tone Detector circuit pack, if required.

Connect Cables

1
Install and connect cables from the TN464GP to the Main Distribution Field as required.

Administer the Circuit Pack

1
Administer the screens listed under ISDN Trunk Group and Trunk Group screens described in the
Screen Reference chapter in the Administrator's Guide for the Avaya™ Communication Manager.

Resolve Alarms

1
Type display alarms and press
2
Examine the alarm log. Resolve any alarms that may exist using the appropriate maintenance
documentation.

Save Translations

1
Type save translation and press
to the hard drive.
48
TRUNK GROUP STATUS
Service State Mtce Connected Ports
Busy
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
.
Enter
to take all translation information in memory and write it
Enter
Enter .
Adding New Hardware--S8700
November 2003