Table of Contents
Advertisement
connected to the HMS 400 server. If this requirement is not met, power transients can cause
personal injury, hardware failure, or both.
Procedure
1. Plug the HMS 400 server AC power cord into the HMS 400 server rear panel.
2. Plug the opposite end of the HMS 400 server AC power cord into a wall receptacle
Starting HMS 400 server
About this task
You can start the HMS 400 server approximately 20 seconds after the server connects to AC
power. The power-control button becomes active and one or more fans might start running to
provide cooling while the server is connected to power.
Prerequisites:
• If a power failure occurs while the server is turned on, the server restarts automatically
when power is restored.
• If you installed an optional Remote Supervisor Adapter II SlimLine, you can turn on the
server from the Remote Supervisor Adapter II SlimLine user interface.
• If your operating system supports the Wake on LAN feature, the Wake on LAN feature
can turn on the server.
Procedure
1. To start the server, press the server power switch.
2. Observe the Power-On Self-Test (POST) and initialization messages on the
Avaya Hospitality Messaging Server 400 Installation and Commissioning
or power bar.
monitor.
Starting HMS 400 server
March 2012
51
Advertisement
Table of Contents
