Agilent Technologies InfinityLab LC Series User Manual page 120

5
Preparing the Module
Setting up the Vialsampler
Table 12 The Vialsampler User Interface
120
Within the sampler user interface, there are active areas.
If you move the mouse cursor across the icons (tray, EMF
button), the cursor will change and you may click on the
icon to
1
Turn on/off the sampler
2
Check which sample drawers are installed
3
Get the status of the EMF (Early Maintenance
Feature)
4
Cooling Temperatur (if sample cooler or sample
thermostat is installed)
Current instrument information on:
• Injection volume
• Sample location
A right-click into the Active Area will open a menu with
the option to adjust the following parameters:
• Show the Control User Interface (special module
settings). See "Control Settings"
• Show the Method User interface (same as via menu
Instrument > Set up Instrument Method > Setup
G7129B). See "Method Parameter Settings"
page 124.
• Injector Program
When you activate a pretreatment/injector program, it
replaces the standard injection cycle. See
Injector Program"
• Identify Device
• Home Arm
• Reset Injector
• Release Vial
• Switch Valve to Bypass
• Switch on Tray Illumination
• Needle Wash: allows you to wash the needle without
modifying your current method. The needle wash
specified in this dialog box is carried out immediately.
• Modify
• Flow Path: for the sample loops, needle seat,
extension loops and metering devices
• External Tray
• Temperature Mode
Agilent InfinityLab LC Series Vialsamplers User Manual
on page 122.
"Using an
on page 134
on