Inserting An Avaya X330Stk Stacking Module - Avaya G700 Installation And Upgrades

2 G700 Media Gateway: Installing the G700 Media Gateway

Inserting an Avaya X330STK Stacking Module

G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other Media
Gateways. The stack is limited to ten elements. To link multiple units, each G700 Media Gateway must be
equipped with an Avaya X330STK Stacking Module which is mounted through the rear panel of the G700
Media Gateway.
!
CAUTION:
The Stacking Sub-Module is not hot-swappable. That is, the G700 Media Gateway must be
powered off before you insert or remove a Stacking Module. If there is an S8300 Media
Server present that is also turned on, the S8300 Media Server should be shut down first, by
pressing the Shutdown button until the OK to Remove LED lights. Then, the G700 should be
powered off.
Insert an Avaya X330STK Stacking Module
Begin
Remove the blank plate from the back of the G700 Media Gateway.
1.
Insert the Avaya X330STK Stacking Module gently in the bay, ensuring that the metal base plate
2.
is aligned with the guide rails.
Figure 8. Insert Stacking Module
Press the Avaya X330STK Stacking Module in firmly until the connector at the back of the
3.
module is completely inserted into the internal connector on the G700 Media Gateway.
Tighten the screws on either side of the module.
4.
End
At this point, the required modules and cabling units have been inserted into the G700 Media Gateway. The
next step will be to prepare the G700 Media Gateway for power.
24
Installation and Upgrades for G700
555-234-100 – Issue 1 – May 2002