Insert An Expansion Module; Insert An Avaya X330Stk Stacking Module - Avaya G700 Installation And Upgrades

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server: Installation and Cabling

Insert an Expansion Module

The Expansion Modules provide increased networking and connectivity capabilities. These modules may be
mounted on the G700 Media Gateway in the slot on the lower left side of the unit below slot V1 (see
Media Gateway with an S8300 Media Server: Front View" on page
!
CAUTION:
The Expansion Module is not hot-swappable. That is, the G700 must be powered off before
you insert or remove an Expansion Module. If there is an active S8300 present, the S8300
should be shut down by pressing and holding the Shutdown button for 2-3 seconds. The OK
to remove LED will flash during shutdown and turn on steady when it is safe to power down.
Insert an Expansion Module into the G700 Media Gateway
Turn off the power to the unit if the equipment has been in operation.
Remove the blank plate covering the bay.
1.
2. Align the printed circuit board with the interior guide rails.
Note: The printed circuit board fits into the guide rail. The metal base plate does not.
Firmly press the Expansion Module into the G700 Media Gateway until it is completely inserted.
3.
Tighten the two screws on the front panel of the Expansion Module.
4.
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all captive
screws must be securely tightened such that they cannot be loosened without the
use of a tool.
!
WARNING:
The Avaya G700 Media Gateway must not be operated with any slot open. Empty slots
must be covered with the supplied blank plates.
At this point, you have readied the G700, inserted the S8300, if required, inserted the media modules and
the Expansion Module, as required in the planning documents. If more than one unit (G700 and/or Level 2
switches and routers) will be connected in the configuration you are installing, the next step will be to insert
an Avaya X330STK Stacking Sub-Module.

Insert an Avaya X330STK Stacking Module

G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other G700s. The
stack is limited to ten elements. To link multiple units, each G700 must be equipped with an Avaya
X330STK Stacking Module, which is mounted through the rear panel (back view) of the G700.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
62).
"G700
77