Removing A Voip Module; Inserting A Voip Module - Avaya IG550 Installing And Configuring

Removing a VoIP module

1. Remove the Phillips screw anchoring the VoIP module to the TGM550 module. See
Figure 51
2. Open the latches on either side of the VoIP module slot. The VoIP module lifts up.
3. Pull out the VoIP module. Touch the module only at the edges.

Inserting a VoIP module

1. Position the
into its slot (see
Figure 51: Inserting the VoIP module
2. Push the
VoIP
3. Flatten the
click shut.
4. Secure the VoIP card to the TGM550 using the Phillips screw.
for the location of the VoIP module on the TGM550 board.
module at a 45 degree angle to the TGM550 module, and start inserting it
VoIP
Figure 51).
module in all the way. Do not use too much force.
module so it is flush with the TGM550 module. The latches at either side
VoIP
Replacing a VoIP module
Issue 2 January 2008 191