Avaya G700 Installation And Upgrades page 30

2 G700 Media Gateway: Installing the G700 Media Gateway
Insert Media Modules
Begin
1. Remove the blank plate from the empty bay.
Position the Media Module squarely before the selected bay on the front of the G700 Media
2.
Gateway chassis and engage both sides of the module in the interior guides.
Slide the module slowly into the chassis, maintaining an even pressure to assure that the module
3.
does not become twisted or disengaged from the guides.
Figure 7. Insert Media Module
Apply firm pressure to engage the connectors.
4.
The Media Module connector has different length pins. The long pins will engage first to provide
grounding. Medium length and short pins will provide power and signal.
Lock the Media Module into the chassis by tightening the spring-loaded captive screws on the
5.
front of the module.
End
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all captive
screws must be securely tightened such that they cannot be loosened without the use
of a tool.
At this point, you have readied the G700 Media Gateway, inserted the S8300 Media Server, if required, and
inserted the Media Modules as described in the planning documentation. Next, if required, the Expansion
Module should be inserted into its bay.
22
Installation and Upgrades for G700
555-234-100 – Issue 1 – May 2002