Considerations For Qsig - Avaya G700 Installation And Upgrades

4 Connecting to Other Systems: Networking an Avaya
Table 6. Administration of ISDN-Based DCS Network Continued
Administration Task
Administer Synchronization Plan
Administer Signaling Group
Assign trunk groups
Administer dial plan
Administer uniform dial plan
Administer AAR analysis
Administer TSC Gateway Channel
Assignment (If Gateway)-
Assign Hunt Groups-
Assign Processor Channels

Considerations for QSIG

DCS+ configurations in Figure 21 and Figure 22 also apply in a network that uses QSIG. There are some
differences in the setup between QSIG and DCS+:
• The circuit packs for each node's connection must administered for:
- PBX connection
- Peer-master or peer-slave interface
- QSIG protocol
- ISDN-PRI signaling mode
- Sequential or timeslot channel numbering
Installation and Upgrades for G700
555-234-100 – Issue 1 – May 2002
TM
S8300 Media Server to Other Switches
Comment
Set the stratum and board type for
synchronization.
Create a signaling group for the ISDN
network trunks. You assign this signaling
group to trunk group(s) when administer
the IP trunk group(s).
On Page 2 of the Signaling Group screen,
you must administer, for each network
node, an Non-Call-Associated Temporary
Signaling Connection (NCA TSC) extension
for DCS signaling. You must enter DCS in
the Appl. field.
Unlike DEFINITY csi/si/r, S8300 can use
the same trunk group for call data and DCS
control data. The trunk group must an ISDN
group type and tie service type. On Page 2,
you enable the trunk group for DCS and
assign DCS signaling to the D-channel.
You must establish that the local dial plan
will be included in a Uniform Dial Plan and
begin defining the UDP.
Define the UDP to match extensions with
remote phone numbers.
Define AAR analysis to determine which
node to send the call after UDP processing.
Define a gateway for network nodes if one
of the nodes uses IP and the other uses
ISDN-PRI.
See Intuity AUDIX Administration .
Assign a processor channel for DCS. You
must enter DCS in the Appl. field and, for
S8300, p in the Interface Link field.
75