Replacing An Avaya Octaplane Stacking Module; S8500 Component Maintenance - Avaya MCC1 Maintenance Procedures

Component replacement

S8500 component maintenance

5 Align the printed circuit board with the interior guide rails.
NOTE:
Note: The printed circuit board fits into the guide rail. The metal base plate does not.
6 Firmly press the Expansion Module until it is completely inserted into the G700.
7 Tighten the two screws on the front panel of the Expansion Module.
!
To prevent access to electrical hazards by unauthorized personnel and to ensure continued
compliance to international radiated emissions requirements, all captive screws must be securely
tightened such that they cannot be loosened without the use of a tool.
Replacing an Avaya Octaplane Stacking
Module
G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other G700s. The
stack is limited to ten elements. To link multiple units, each G700 must be equipped with an Avaya
Octaplane Stacking Module, which is mounted through the rear panel of the G700. See Hardware Guide
for Avaya Communication Manager, 555-233-200 for a general description of the hardware.
Insert an Avaya Octaplane Stacking Sub-
Module
1 Undo the cables.
2 Remove the blank plate from the back of the G700.
3 Insert the Avaya Octaplane Stacking Sub-Module gently in the slot, ensuring that the metal base
plate is aligned with the guide rails.
4 Press the Avaya Octaplane Stacking Sub-Module in firmly until the connector at the back of the
module is completely inserted into the internal connector on the G700.
5 Tighten the screws on either side of the module.
S8500 component maintenance
This section contains procedures for the following equipment:
• Replacing the S8500 hard drive
• Replacing the S8500 Media Server
• Replacing the Remote Supervisor Adapter (RSA)
• Replacing the Remote Supervisor Adapter (RSA)
302
WARNING:
on page 303
on page 303
on page 304
on page 304
Maintenance Procedures
December 2003