Install Rear Panels - Avaya S8700 Installing Manual

122
Installing an Avaya SCC1 Media Gateway Stack

Install Rear Panels

1 Install the rear panels and loosely thread each screw. See
on page
For un-stacked media gateways, tighten the screws securely.
2
For a stack of media gateways, allow the screws labeled callout 4 to remain loose. These
screws are tightened when the ground plates are installed.
3 Be sure the Time Division Multiplexing (TDM) bus cables and the Inter-Cabinet Cables
(ICC) are not pinched by the panels. Also be sure the cables are routed through the
channels provided on the rear panels.
Rear Panel Screw Locations
Figure notes
1 Expansion Control Media Gateway A (No ground plate is installed on an un-stacked
media gateway)
2 Rear Ground Plate (attached between stacked media gateways)
3 Port Media Gateway B
Screws to Loosen
4
122.
1
October 2002
''Rear Panel Screw Locations''
3
4
2
4
grnd_plt CJL 030696