Unpack And Inspect Auxiliary Cabinet; Check Circuit Packs - Avaya S8700 Installing Manual

66
Installing an Avaya MCC1 Media Gateway
1 Check the status of the SHOCKWATCH and/or TILTWATCH indicators on the
container. If the container has been shaken or tilted beyond specifications, the indicators
are red, indicating potential damage. Report any damage according to local shipping
instructions.
!
DANGER:
Take care to avoid injury while cutting and removing the 2 metal bands.
2 Unpack the media gateway and remove all packing material.
Move the media gateway into its proper position.
3
4 Do not adjust the leveling feet at this time.

Unpack and Inspect Auxiliary Cabinet

The auxiliary cabinet can be positioned adjacent to the control hardware in the rack or any
media gateway.
1 Check the status of the SHOCKWATCH and/or TILTWATCH indicators on the
container. If the container has been shaken or tilted beyond specifications, the indicators
are red, indicating potential damage. Report any damage according to local shipping
instructions.
!
DANGER:
Take care to avoid injury while cutting and removing the 2 metal bands.
Unpack the cabinet and remove all packing material.
2
3 Move the cabinet into its proper position.
Remove the lower rear panel from the auxiliary cabinet.
4
NOTE:
You reinstall the lower rear panel when the installation is completed.

Check Circuit Packs

1 Ensure all circuit packs are fully inserted into the proper slots according to the System
Diagram shipped with the S8700 Multi-Connect configuration.
Report any discrepancies in circuit pack type or quantity to your Avaya representative.
For detailed circuit pack descriptions, refer to Designing the Avaya S8700 Media
Gateway for Multi-Connect Configuration.
2 Check the S8700 Multi-Connect configuration adjuncts for damage and report all
damage according to local shipping instructions.
October 2002