Configure Media Server 2; Verify Software Version - Avaya S8700 Installing Manual

44

Configure Media Server 2

NOTE:
Make sure your networking and Web browser settings are correct. Refer to the job aid
entitled Pre-Installation Information—S8700 Media Server.
1 Plug media server 2 into UPS 2 to power it up. Refer to
S8700 Media Server with MCC1 or SCC1 Media
2 Plug the laptop into port 2 (Eth1) on the back of media server 2 using the black crossover
cable.
3 On the services laptop, click Start > Run to open the Run dialog box.
Type command and press
4
Type arp -d 192.11.13.6 and press
5
cache in the laptop. This command will respond with one of the following:
Launch the Web browser.
6
7 Type 192.11.13.6 in the Location (Netscape) or Address (Internet Explorer) field to bring
up the Web interface.
8 Log in as craft.
When asked "Do you want to suppress alarms?", select "yes."
9

Verify Software Version

NOTE:
The menu choices are in the left panel
Scroll down the menu to Server Configuration and Upgrades
1
Click View Software Version. Note the software version displayed and compare it to the
2
required version. (check against the Software Release Letter that comes with the
software CD).
Enter
The command line prompt when the cache has been cleared.
•
• The phrase: "The specified entry was not found." This is returned when the
specified IP address does not currently contain an entry in the ARP cache.
October 2002
Getting Started with the Avaya™
Gateway.
to open an MS-DOS Command Line window.
to clear the Address Resolution Protocol (ARP)
Enter