Connect The Hardware; Connect The Ethernet Switch Cables To Ipsi Circuit Packs; Avaya Mcc1 Media Gateway; Avaya Scc1 Media Gateway - Avaya S8700 Installing Manual

Connect the Hardware

This section covers the following tasks:
• ''Connect the Ethernet switch cables to IPSI circuit packs'' on page 193
• ''Connect Avaya SCC1 media gateway IPSI and maintenance circuit pack ribbon
cables'' on page 199
• ''Program the IPSI circuit packs'' on page 205
''Using DHCP addressing'' on page 206
•
• ''Using static addressing'' on page 208
• ''Verify connectivity to the media servers'' on page 211
''Avaya MCC1 Media Gateway'' on page 193
•
• ''Avaya SCC1 Media Gateway'' on page 193
''Verify connectivity to the media servers'' on page 211
•
• ''Verify IPSI firmware version'' on page 211
• ''Enable control of IPserver interfaces'' on page 212
''Connect the USB Modems'' on page 212
•
Connect the Ethernet switch cables to IPSI circuit
packs

Avaya MCC1 Media Gateway

Refer to Getting Started with the Avaya™ S8700 Media Server for Multi-Connect
Configurations

Avaya SCC1 Media Gateway

Refer to Getting Started with the Avaya™ S8700 Media Server for Multi-Connect
Configurations
connect the Ethernet cables at the SCC1 media gateway.
If not already removed, remove the ground plate. Remove the upper and lower rear
1
covers from the media gateway(s).
for a connectivity guide.
for a general connectivity guide. Use the following detailed steps to
October 2002
193
Connect the Hardware