Test Expansion Interface Exchange For Each; Port Network (S8700 Multi-Connect Only) - Avaya S8700 Installing Manual

1 Type test tdm port-network 1 and press
2 Verify a test results screen similar to
is displayed.
3 If result is FAIL for any test, check the connectors of the TDM bus cables in PN 2.
Repeat these steps for each PN to check the TDM bus cables.
4
Sample Test Results for TDM Bus Port Network 1
test tdm port-network 1
Port Maintenance Name
PN 01A TDM-BUS
PN 01A TDM-BUS
PN 01A TDM-BUS
PN 01B TDM-BUS
PN 01B TDM-BUS
PN 01B TDM-BUS

Test Expansion Interface Exchange for Each

Port Network (S8700 Multi-Connect only)

If the configuration is critical reliability, test the expansion interface exchange for each Port
Network (PN).
Type status port-network number <1-64> and press
1
This displays the standby expansion link. See
Expansion Link is Set—S8700
Type set expansion-link UUCSS, where UUCSS is one of the cabinet, carrier, and port
2
locations of the standby expansion link, and press
Verify the bottom of the screen displays:
3
Command successfully completed
4 Type status port-network number <1-64> and press
A screen similar to
Multi-Connect" displays.
Verify that the MODEs of the expansion links have changed.
5
6 If any problems are indicated, check the TDM cables and the inter-cabinet cables (ICC)
in the associated port network.
Enter
"Sample Test Results for TDM Bus Port Network 1"
TEST RESULTS
Alt. Name Test No. Result
294
296
297
294
296
297
Multi-Connect".
"Sample of Port Network Status after Expansion Link is Set—S8700
October 2002
Testing the Complete Configuration
.
PASS
PASS
ABORT 1005
PASS
ABORT 1005
PASS
.
E nter
"Sample of Port Network Status before
.
Enter
.
Enter
311
Error Code