Avaya S8700 Installing Manual page 209

Connecting directly to the IPSI
1
cadlipsi KLC 031502
Figure notes
Services laptop
1
PCMCIA Network Interface Card (NIC)
2
1 Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
Click Start > Run to open the Run dialog box. (services laptop)
2
Type command and press
3
4 Type arp -d 192.11.13.6 and press
command will respond with one of the following:
• The command line prompt when the cache has been cleared.
The phrase: The specified entry was not found. This is returned when the
•
specified IP address does not currently contain an entry in the ARP cache.
5 Type telnet 192.11.13.6 and press
IPSI.
Prompt = [IPSI]:
NOTE:
While connected to the IPSI type help or ? to obtain online help. Most commands have
two or three letter abbreviations.
Type ipsilogin and press
6
2
3
3
4
to open a MSDOS Command Line window.
Enter
to clear the ARP cache in the laptop. This
Enter
to open the Telnet window and connect to the
Enter
. (abbreviated command = il)
Enter
October 2002
Connect the Hardware
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
4
NIC adapter cable (if necessary)
CAT5 crossover cable to IPSI
209