Fip1.17 072-100 Iot Tray2 Misfeed Jam - Fuji Xerox DocuPrint M355df Service Manual

FIP1.17 072-100 IOT Tray2 Misfeed Jam
Step
Parts considered to be the cause
Tray 2 Feed Roll / Nudger Roll [ROLL ASSY FEED]
(PL10.2.13) (Option)
Tray 2 Retard Roll [HOLDER ASSY RETARD CST]
(PL10.3.3) (Option)
Regi. Sensor [HVPS] (PL18.2.5)
CLUTCH ASSY OPT FEED (PL10.1.8) (Option)
MOTOR-ASSY OPTION (PL10.1.19) (Option)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among the
3
parts considered to be the cause in sequence) deformed or
worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the oper-
4
ation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check the operation of the CLUTCH ASSY OPT FEED
(when the Option Tray is installed)
5 Execute the Diag Digital Output [071-018] to check the
operation of the CLUTCH ASSY OPT FEED.
Is the CLUTCH ASSY OPT FEED operating normally?
Check the operation of the MOTOR-ASSY OPTION (when
the Option Tray is installed)
6 Execute the Diag Digital Output [071-009] to check the
rotation of the MOTOR-ASSY OPTION.
Is it working properly?
Check and Action
2-63
Chapter 2 Troubleshooting
2.3 Error Code FIP
Yes
Remove the
foreign sub-
stances and
bits of paper,
etc.
corresponding
Go to Step 3.
Replace the
corresponding
paper feed
rolls
Go to Step 5.
Go to Step 6. Go to FIP2.10
Replace the
PWBA MCU. Go to FIP2.14
(REP 18.2)
No
Go to Step 2.
Reinstall the
paper feed
rolls
Go to Step 4.
Go to FIP2.2