Iot Zone Msi + T1 + T2 Jam; Iot Zone Msi + T1 Jam; Iot Remain Zone Regi + Msi + T1 Jam - Fuji Xerox DocuPrint M355df Service Manual

Chapter 2 Troubleshooting
2.3 Error Code FIP
FIP1.13 050-132 IOT Remain Zone Regi + MSI + T1 + T2 Jam

050-133 IOT Zone MSI + T1 + T2 Jam

050-134 IOT Zone MSI + T1 Jam

050-142 IOT Remain Zone Regi + MSI + T1 Jam

Step
Parts considered to be the cause
ROLL ASSY RUBBER (PL15.2.6)
ROLL ASSY REGI PINCH (PL15.2.8)
ROLL REGI PINCH (PL15.2.37)
MSI Feed Roll / Nudger Roll [HOLDER ASSY PICK UP]
(PL13.1.15)
KIT RETARD ROLL MSI ASSY(PL13.2.98)
Tray 1 Feed Roll / Nudger Roll [FEEDER ASSY] (PL15.3.2)
Tray 1 Retard Roll [HOLDER ASSY RETARD CST]
(PL9.1.3)
Transfer Unit [ROLL ASSY-TRANS CRU] (PL6.1.1)
Drum Cartridge [XERO ASSY] (PL8.1.1)
Tray 2 Feed Roll / Nudger Roll [ROLL ASSY FEED]
(PL10.2.13) (Option)
Tray 2 Retard Roll [HOLDER ASSY RETARD CST]
(PL10.3.3) (Option)
Regi. Sensor [HVPS] (PL18.2.5)
REGI. CLUTCH (PL15.2.4)
SOLENOID FEED MSI (PL13.1.5)
CST FEED CLUTCH (PL15.2.16)
CLUTCH ASSY OPT FEED (PL10.1.8) (Option)
MOTOR-ASSY OPTION (PL10.1.19) (Option)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among the
3
parts considered to be the cause in sequence) deformed or
worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the oper-
4
ation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check the REGI. CLUTCH operation
Execute the Diag Digital Output [071-006] to check the
5
operation of the REGI. CLUTCH.
Is the REGI. CLUTCH operating normally?
Check and Action
2-58
Yes
Remove the for-
eign sub-
Go to Step 2.
stances and bits
of paper, etc.
Reinstall the
correspond-
Go to Step 3.
ing paper
feed rolls
Replace the cor-
responding Go to Step 4.
paper feed rolls
Go to Step 5. Go to FIP2.2
Go to Step 6. Go to FIP2.8
No