Fuji Xerox DocuPrint M355df Service Manual page 409

Chapter 6 General
6.4 Service Mode
Function
Digital Input
Digital Output
NVM
Settings
IOT Diag
ROS Exposure
Dew Prevention
ATC Mode
Config Page
Print Info
Print Settings
Table 6-28 Function Names and Descriptions (Printer Diag)
Checks whether the DI (digital input) components such
as sensors and switches on the IOT are functioning
properly.
Checks whether the DO (digital output) components
such as motors and clutches are functioning properly.
Reads and writes the content of the NVM of the IOT for
Edit NVM
the Chain Link specified.
Save NVM to
Saves the IOT NVM information to the ESS NVM.
ESS
Loads the information saved in the ESS NVM to the IOT
NVM.
Load NVM
(If [Save NVM to ESS] has never been executed, no
from ESS
NVM backup data is stored, and therefore this item is
not displayed.)
Corrects the variation in the Lead-Regi of the ROS.
Sets whether to enable the Dew Prevention mode.
Sets whether to enable the ATC (Automatic Toner Con-
trol) empty detection mode.
ON: Changes the toner cartridge detection method to
the count method.
OFF: Changes the toner cartridge detection method to
the ATC method.
Prints the printer configuration information. (Available
print size is A4.)
Prints the printer setting information. (Available print
size is A4.)
Description
6-34
See
6.6.1
6.6.2
6.6.3
6.6.4
6.6.5
6.6.6
6.7.1
6.7.2